Please Note: We cannot currently process orders with any items covered by the PACT Act outside of Florida.

We will be adding additional locations as circumstances permit.
All orders received from the state of Florida will be processed with the shipping method currently available:
USPS Priority Mail with adult signature required. Non-covered items can be shipped anywhere.

Other products by HV
Item #: VA09620
Reg. Price: $54.95
Our Price: $14.95
Color  
Quantity:
 

Description  more details

Step1 - Have a pre punched cartomizer ready to install. Make sure the cartomizer is not deformed by the punching. The cartomizer must be round. 

Step 2 - Remove the top cap. This should remove with very little effort! Never force the top cap off by prying with a knife or other device. The cap should release with slight pulling/twisting motion.

Step 3 - Prefill your cartomizer with liquid. Lubricate all o rings with VGPG, or your liquid. Lubricate the outside metal case of your cartomizer. Leave the little white cap on the cartomizer, or use a carto tool or drip tip that is no wider than the cartomizer. Push the cartomizer up into the tank, from the bottom going up, careful not to damage the o ring. The drip tip or carto protects the o rings from being cut by the sharp edges of the cartomizer edge. The most important thing is to lube the outer part of the cartomizer before trying to install. Line up the bottom of the cartomizer with the bottom of the lower cap. It does not have to go all the way up into the top cap! Air flow area is needed.

Step 4 - Fill your tank with liquid, about 2ml, leaving enough space for the top cap, about 1/4". 

Step 5 - Take the top cap and lube the o ring. This is critical! Slide the hole in the top cap over the cartomizer,  just to the o ring, so you have a very loose seal. Now tilt the tank so the air bubble is over one of the holes in the cartomizer. Push the top cap all the way on now. With the juice as lubrication, this should click right in without too much effort.

Step 6 - Blow out any excess liquid that got into the cartomizer, or let the tank sit upright for a minute, so the excess liquid can drain out. 

Step 7 - Connect the tank to the device of your choice and enjoy.

Always lube o rings!
O rings will swell a bit, so don't panic if you think the fit is too loose. It will tighten up as liquid absorbs into the o rings. This takes only a few minutes.

 

Reviews

Be the first to submit a review on this product!
Review and Rate this Item
If you have any problems or questions placing an order, please feel free to contact us between 10AM and 6PM, Eastern Time, Monday through Friday at 1-305-255-5427.

PLEASE NOTE: Orders placed before 2PM Eastern time will usually ship on the same day. Orders placed after this time will usually ship the next business day. When your order ships, you will be sent an email with tracking information. Please keep in mind that packages are taking longer than usual and we cannot control the time in transit.


IMPORTANT: in order to comply with the PACT Act, all covered items shipped to US addresses will be sent with a requirement for adult signature. Thank you for your patience.
Due to credit card fraud activity, we have increased security on the web site,
including enhanced billing address verification and Captcha.
We apologize for the inconvenience.

Share







Pin It

Email A Friend

Send your friend a link to this product.